Timer for wafer drying oven

Mon, 08 Jun 2026 02:24:02 +0800

Out of the cleaning bath, a wafer comes with a skin of DI water. The drying oven has to strip that moisture off without cooking the photoresist or kicking up particles. If the timer drifts, dwell time wanders—and that shows up on the line as yield leak. So we built a timer for wafer drying ovens that keeps the process honest. What it has to do, technically This timer is meant for semiconductor thermal gear. Timing accuracy hits 0.1%, and repeatability is ±10 ms. It plugs straight into oven control loops, with 24 VDC and PLC interlocks, and it’s IP54-rated for the wet, chemical-heavy air around cleaning bays. Cleanroom-compatible construction, low-outgassing materials, and a display that shows elapsed time and cycle complete—no guesswork. The interface stays deliberately clean: set, start, confirm. Why this matters on the drying step Wafer drying lives on a tight thermal budget. If the cycle’s too short, you get water marks. Too long, and you risk photoresist reflow, or you set yourself up for edge bead headaches after the next coat/bake. This timer pulls the operator variable out of it and locks in the same cycle, lot after lot. You end up with consistent dryness, fewer reworks, and particle counts that don’t swing shift to shift. It also keeps the paperwork straight, logging cycle times for SPC without adding noise to the line. What you need to know for install Install comes down to matching the oven’s control voltage and interlock logic. We provide wiring diagrams and calibration offsets so the timer’s window lines up with the oven’s ramp and soak. Schedule a 15-minute integration check during a maintenance window. The timer is tough, but it’s not a replacement for temperature control. Pair it with a verified oven thermal uniformity plan, and you’re set.

Oven on Warm IR Heaters for Home

Timer for wafer drying oven